Quick Start - DeFelsko PosiTector CMM IS Mode D'emploi

PosiTector CMM IS Expansion Packs are available when
additional probes are required. A single expansion pack consists
of the following:
PosiTector CMM IS probe
Calibration Check Chamber
Saturated Salt Solution (NaCl)
PosiTector CMM IS probe
Stackable Probe
Extensions
Batteries
NOTE:
For instructions on how to use the PosiTector CMM IS
and the PosiTector App in accordance with ASTM F2170, refer
to Setting Up a New ASTM F2170 Project (pg. 6).
PosiTector CMM IS probes are designed for use with the
PosiTector App or a PosiTector Advanced Gage.
Power-up PosiTector CMM IS probes by unscrewing the battery
cover and inserting the battery (positive "+" facing up). Replace
the battery cover. The probe will begin broadcasting and is now
visible to the PosiTector App and PosiTector Advanced
instruments.
To power down the PosiTector CMM
IS probe, unscrew battery cover and
remove battery using a pointed tool,
such as the probe extraction tool.
Expansion Packs

Quick Start

2
Cap
(2) A-76 / LR-44 batteries
(2) Stackable Probe
Extensions
Calibration
Check
Chamber
Fins
Cap