DeFelsko PosiTector CMM IS Mode D'emploi page 12

To Record Measurements Using a PosiTector DPM Advanced:
1. Access the Connect Menu within the gage menu.
2. Under Bluetooth Smart, select Smart Probes (shown
below). Available PosiTector CMM IS probes will be visible.
Select the probe to be recorded.
3. The relative humidity and temperature measured by the
PosiTector CMM IS probe will be displayed below the ambient
relative humidity, air temperature and surface temperature
measured by the PosiTector DPM probe, as shown below:
To record, ensure a batch is open in memory and press the (+)
button on the gage. The displayed readings of the PosiTector DPM
probe and the PosiTector CMM IS probe will be recorded into the
gage's memory. If a batch is not currently open, select New Batch
from the gage's Memory menu. To add measurements to an
existing batch, select Open from the gage's Memory menu.
Measurements from multiple PosiTector CMM IS probes can be
recorded within the same batch by repeating the above steps for
each probe in the project.
11