Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The PosiTector Replica Tape Reader (RTR H) is a hand-held
electronic instrument that measures burnished Testex Press-O-
Film
replica tape to produce peak-to-valley surface profile height
TM
measurements. It consists of a PosiTector body (Standard or
Advanced) and probe.
Press the
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in Sleep Mode, the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select Power Off from the main menu. All settings
are retained.
NOTE:
To ensure best accuracy, the user will be prompted to
zero the probe every time the Gage is powered-up. It is therefore
recommended to clean the probe regularly with the included clean-
ing card. Cleaning is best performed when the Gage is powered
down.
With the Gage powered down...
1. Clean the probe with the included cleaning card (pg. 5).
2. Power-up Gage by pressing the center navigation button
3. Zero the probe (pg. 6).
4. Verify Gage accuracy (pg. 5).
5. Measure the burnished replica tape (pg. 3).
To access the Menu, power-up the gage, then press the center
navigation button
used to navigate the menu. If desired, touch screen functionality
can be disabled within the Setup menu (See Touch, pg. 9).
Select a menu option by touching it, or use the
tons to highlight the desired option and press
On menus longer than one page, the current page number is dis-
played below the menu name. Navigate between pages using
when the first menu item is selected, or
Introduction
Quick Start
button to power up the Gage. To conserve battery
Menu Operation
. Either the keypad or touch screen can be
1
and
but-
to select it.
when the last
.
Publicité
Table des Matières
