Quick Start; Menu Operation - DeFelsko PosiTector 6000 Guide D'utilisation

The PosiTector 6000 powers-up when the center navigation
button is pressed. To preserve battery life, the instrument
powers down after approximately 5 minutes of no activity. All
settings are retained.
1. Remove the protective rubber cap (if supplied) from probe.
2. Power-up Gage by pressing the center navigation
3. Place the probe FLAT on the surface to be measured.
HOLD STEADY. When a valid measurement is calculated,
the Gage BEEPS twice and the measurement is displayed.
4. Lift probe AT LEAST 2 INCHES (5 cm) from the surface
between measurements - OR - leave probe on the surface
in the same location for continuous measurements.
Gage functions are menu controlled. To access the Menu,
power-up the gage, then press the center navigation button.
To navigate, use the Up and Down buttons to scroll vertically and
to SELECT.
Previous Page
(Exit)
Access the Menu
(Center/Select)
Introduction

Quick Start

Menu Operation

Next Page
Up
Down
( + )
Press the
pages in a multipage menu.
Press the (-) button to return
to the previous menu or page.
Select Exit to exit from any menu.
1
button.
button to switch