Rear Mounting Options - Kärcher MIC 70 Mode D'emploi

Attachment
1
Rear supports
2
Locking device for attachment (2x)
3
6. Get in, and completely lower the attachment frame.
7. Remove the rear supports from the attachment.
Retaining pin (2x)
1
Retaining clip (2x)
2
8. Secure the attachment to the left and right (retaining pin
and retaining clip are a part of the attachment frame).
During first installation or when changing the carrier ve-
hicle, the fixing must be set, see chapter 9.4.3 Setting
the fixing.
9. Deal with the hydraulic and electrical connections after
doing the fitting.
9.4.5 Removing the attachment from the vehicle
Front supports
1
Rear supports
2
1. Completely lower the attachment frame.
2. Disconnect the hydraulic and electrical connections pri-
or to the dismantling.
3. Remove the retaining pins to the left and right.
4. Insert the two rear supports as far as they will go.
5. Lift the attachment frame far enough until the front sup-
ports can be inserted.
6. Get in, and completely lower the attachment frame.
7. Insert the two front supports as far as they will go.
8. Lower the attachment frame.
9. Cautiously drive the vehicle out.
9.5

Rear mounting options

9.5.1 Rear mounting frames
Counterweights and certain attachments can be attached
directly to the mounting frame for attachments.
Mounting frames
1
1. Push the attachment into the mounting frames and se-
cure using 2 bolts.
English 69