Kärcher MIC 70 Mode D'emploi page 68

9.4.2 Mounting options on the attachment frame
Mounted spreader
1
Interchangeable frame (integrated in the attachment)
2
Attachment frame with tipping function
3
1. Attaching / removing is described using the example of
a mounted spreader.
9.4.3 Setting the fixing
Note
The setting for the fixing of the interchangeable frame must
only be made during first installation or when fitting to an-
other carrier vehicle.
Screw with nut
1
Fixing hook (2x)
2
Attachment frame
3
1. Undo the nuts to the left and right by about 1 revolution.
2. Fit the attachment to the attachment frame and secure
it using retaining pins and retaining clips, see the follow-
ing chapter9.4.4 Fitting the attachment to the vehicle.
3. Completely lower the attachment frame.
4. Press the fixing hook against the attachment frame as
shown.
5. Re-tighten the nuts to the left and right.
68
9.4.4 Fitting the attachment to the vehicle
Vehicle rear
1
Retaining pin with retaining clip (2x)
2
Attachment
3
Rear supports
4
Fixing hook (2x)
5
Front supports
6
1. Remove the retaining pins from the attachment frame to
the left and right (retaining pin and retaining clip are a
part of the attachment frame).
2. With the vehicle rear centred and parallel, (carefully)
drive under the attachment standing on supports as far
as you can go.
Interchangeable frame for the attachment
1
Fixing hook (2x)
2
Attachment frame
3
3. Cautiously lift the attachment frame until the front sup-
port feet come off the ground, whist making sure that the
fixing hooks engage in the attachment frame.
4. Finally, check the secure fit of the fixing hooks.
5. Remove the front supports from the attachment.
English