Mounting Options At The Rear Of The Vehicle - Kärcher MIC 70 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 87
9.3.4 Fitting the attachment on the 4-point mount
WARNING
Risk of injury due to attachments
Do not move or fit any attachments if persons are in the
hazard zone.
1. Drive up to the attachment.
2. Lower the front power lift far enough until the upper cou-
pling points are beneath the mounts for the attachment.
3. Pull the lever for the central lock upwards, and push it to
the right in order to open the lock.
4. Drive up to the attachment until the mounts come into
contact.
5. Cautiously move the front power lift upwards until the at-
tachment is lifted into the mounts and fixed in place.
6. Push the lever on the central lock to the left again; the
lever must engage in the holder in order to lock the at-
tachment.
9.3.5 Detaching the attachment on the 4-point mount
1. Lift the attachment off the ground.
2. Release the central lock.
3. Lower the 4-point mount with front power lift far enough
until the mounts of the attachment are exposed.
4. Drive away from the attachment.
5. Close the lever for the central lock again before the 4-
point mount is raised upwards completely.
9.3.6 Front mounting frames
Certain attachments can be attached directly to the mount-
ing frame for attachments.
Mounting frames
1
1. Push the attachment into the mounting frames and se-
cure using 2 bolts.
9.4

Mounting options at the rear of the vehicle

9.4.1 Attachment frame with tipping function (option)
Possible attachments on the attachment frame: Spreader,
water drum or the grass / leaf vacuum container on a mow-
er / vacuum combination.
Attachment frame with tipping function
1
1. The attachments are fitted on a Kärcher interchangea-
ble frame or on an integrated interchangeable frame
from the attachment manufacturer, and are fitted and
secured on the attachment frame.
Control lever
1
2. The attachment frame is controlled using the control le-
ver at the right of the joystick.
Switch for "double-acting control hydraulics AUX rear" /
1
"attachment frame with tipping function"
3. To activate, switch the switch over to "attachment frame
with tipping function".
English
67

Publicité

Table des Matières
loading

Table des Matières