Service Indicator; Maintenance Intervals; Vehicle Maintenance Plan (To Be Carried Out By Customer) - Kärcher MIC 70 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 87
CAUTION
Risk of injury due to inadvertently starting up vehicle.
Before you clean and service the vehicle, or exchange
parts or adjust them to a different function, switch off the
vehicle and remove the ignition key.
CAUTION
Risk of burns from hot surfaces and operating fluids
Allow the vehicle to cool down sufficiently prior to all main-
tenance and repair work.
ATTENTION
Do not let fluids such as engine oil, hydraulic oil, brake flu-
id, diesel or coolants end up in the environment. Dispose
of these fluids in an environmentally friendly manner.
ATTENTION
Repair work may only be carried out by authorised custom-
er service centres or by qualified staff in this area who are
familiar with all relevant safety instructions.
Welding work on the vehicle or vehicle chassis is not al-
lowed.

12.2 Service indicator

The service indicator lights up when the respective main-
tenance needs to be done.
The service indicator flashes on the display:
● after 50 operating hours when the initial inspection
needs to be performed.

12.4 Vehicle maintenance plan (to be carried out by customer)

Pos. Assembly
1
Cabin dust filter
2
Steering
3
Coolant expansion reservoir Check the coolant level.
4
V-belt
5
Screw connections
6
Engine air filter
7
Engine oil
8
Engine oil filter
9
Hydraulic oil tank
10
Hydraulic couplings and con-
nections
72
Activity
Check for contamination.
Clean or renew a contaminated dust filter.
Renew
Visual inspection
Check the bearings on the steering cylin-
der for play.
Check the mixing ratio water / antifreeze.
Check the tension.
Visual inspection; tighten if needed.
Check for contamination.
Clean or renew contaminated engine air
filter.
Renew
Check the oil level prior to travel com-
mencement.
Renew
Renew
Check the hydraulic oil level.
Check for leaks.
English
● Next service after 250 operating hours.
● Then every 500 operating hours.
Note
The service indicator must be reset by the Customer Ser-
vice.

12.3 Maintenance intervals

Note
In order to preserve warranty claims, all servicing and
maintenance work during the warranty period has to be
performed by an authorised Kärcher Customer Service, in
accordance with the inspection check list.
● Daily before starting operation, see chapter 7.2 Safety
check.
● Lubricate all bearings after washing the vehicle.
● If necessary have the safety checks according to the ap-
plicable local regulations performed by the Customer
Service department.
● The intervals for inspection and maintenance work to be
performed by the customer are listed in the following ta-
ble.
Additional maintenance work is to be carried out by the
Customer Service department in accordance with the
inspection checklist after 250, 500 (annually), 1000,
1500 or 2000 operating hours. Please inform the Cus-
tomer Service department in time.
Daily
X
X
X
Weekly
every 500
hours
or once-a-year*
X (depend-
X
ing on envi-
ronmental
conditions)
X (earlier if
needed)
X
X
X
X
X
X
X
X
X
X (earlier if
needed)
X
X
X
X

Publicité

Table des Matières
loading

Table des Matières