Pcc2000 Step Nozzle Installation - Paramount PCC2000 Manuel D'installation

PCC2000 Step Nozzle
Installation
1. Before installing nozzles flush all lines by:
a. Start pump, run for 10 minutes before installing the water
valve module.
b. Install the water valve module and let valve cycle to flush out
any debris remaining in each line.
2. Select nozzle size from pool plan.
3. Place nozzle on a hard surface. Push firmly on cap or strike with
palm of hand to snap firmly into place .
4. Be sure o-ring is pushed all the way up to top flange.
5. Start with nozzle closest to the valve and as red plaster caps
blow out install nozzles.
6. Snap the nozzle onto the install tool by twisting.
7. Place step nozzle assembly in the body and turn clockwise until
snug.
PCC2000 Step Nozzle
(Australia Only)
1/4"
5 GPM
3/8"
10 GPM
5/8"
20 GPM
O-RING
1/4"
5 GPM
3/8"
10 GPM
5/8"
20 GPM
O-RING
NOZZLE TOOL
PART# #004-552-5452-00
26