Paramount Module Alignment Guide - Paramount PCC2000 Manuel D'installation

TO FUNCTION PROPERLY IT IS IMPERATIVE THAT THE MODULE BE PLACED
IN CORRECT ORIENTATION TO THE BASE. TO ENSURE THIS IS DONE, PLEASE
1. Look at the top of the Module - (Fig 1 and Fig 3)
2. Locate the Multiport Tube Assembly - (Fig 1A and Fig 3A)
3. Look at the Base - (Fig 2 and Fig 4)
4. For 2 port: Base (Fig 2) Notice the ribs in the base have been molded to allow water to flow between two sets of three ports - Fig 2A
For 4 port: Base (Fig 4) Notice the two ribs in the base have been cut out to allow water to flow between three ports - (Fig 4A)
5. One open port is centered between two plugged ports - (Fig 2B and Fig 4B)
6. When installed, the port centered under the Multiport Tube Assembly (Fig 1B and Fig 3B) on the Module must be centered over the open port in
the Base - (Fig 2B and Fig 4B)
If the Module is placed incorrectly, multiple zones of nozzles in the pool will fire at the same time.
2 PORT MODULE PLACEMENT
2 Port Module - Fig 1
2 Port Multiport Tube Assembly - Fig 1A
2 Port Multiport Tube Assembly - Fig 1A
Base - Fig 2
Rib Cutaway - Fig 2A
Rib Cutaway - Fig 2A

Paramount Module Alignment Guide

FOLLOW THESE INSTRUCTIONS.
Fig 1b
5 Gears
Fig 1b
4 PORT MODULE PLACEMENT
4 Port Module - Fig 3
4 Port Multiport Tube Assembly - Fig 3A
Base - Fig 4
Rib Cutaway - Fig 4A
23
Fig 3b
4 Gears
4B