Smooth Body Step Installation Guide - Paramount PCC2000 Manuel D'installation

NOTICE: You can use regular PVC glue on smooth body
1
Make a cutout or opening approximately 1"
deep and 1" bigger than the pipe.
This cutout will be filled with plaster or
other finish coat to create a water stop.
1" bY 1" CUTOUT
AROUND ThE PIPE
FOR WATER STOP
CONCRETE
CUT PIPE hERE
SOIL 2" ELbOW

Smooth Body Step Installation Guide

2
Cut off riser pipes flush with concrete
surface.
4
Glue the body into the pipe with a regular
PVC glue.
2" PIPE
The glue must cover the full length of the
body barrel and 3" deep inside the riser
pipe. Push the body into the pipe until the
shoulder hits the top edge of the pipe.
Let fumes vent for 30 minutes then replace
all body caps.
21
3
Remove cap. Prime the inside of the pipe.
DO NOT PRIME ThE bODY.
5
PLASTERING THE POOL
Leave all plaster caps in place for removal
at start up.
NOTE: Optional, the plaster crew may
remove the plaster caps as they finish.
NOTE: The body does not come with the
nozzle installed.