Supplying Power; Changing The Voltage Setting - Struers Accutom-5 Mode D'emploi

Supplying Power

Changing the voltage setting

4
Accutom-5
Instruction Manual
Always remember to switch the power off when installing electrical
equipment!
Check that the mains voltage corresponds to the voltage stated
on the type plate on the back of the machine.
The factory setting for Accutom-5 is 240V.
If the factory setting is not the correct setting for your mains supply the
setting can be changed from 240V to 220V:

Pull out the fuse holder from the cable terminal at the back of the
machine.

Pull out the voltage switch and turn it to the correct setting.
Voltage Required
230 or 240V
200 to 220V
Note: The two additional settings, 110V and 120V are not to be used.

Reinsert the voltage switch.

Put the fuse holder back into the cable terminal.
DANGER!
The machine must be earthed
IMPORTANT
Setting
240V
200V