Struers Accutom-5 Mode D'emploi page 14

Front Panel Controls
Name Key

MAIN
SWITCH


START


STOP

F1/F2
F3/F4
FUNCTION
KEYS




MENU


ENTER
10
Accutom-5
Instruction Manual
Function
The main switch is located on
the back of the machine.
Starts the cutting process
according to the pre-set method.
The recirculation water, if
selected, is turned on.
Stops the cutting process. The
recirculation water, if selected, is
turned off.
Controls for various purposes.
See the bottom of the individual
screens.
Scrolls up () or down () in the
menu tree structure of Accutom-
5. When setting a parameter the
value is increased () or
decreased ( ).
Selects a marked parameter
value or chooses a menu.
Name Key

Esc
ESC
 
FAST
POSITION
LEFT


FAST
POSITION
RIGHT
 
POSITION
LEFT
 
POSITION
RIGHT

/
POSITION
UP/DOWN
Function
Leaves the present menu or
specimen holder position screen.
Changes to POSITION menu or
moves the specimen holder to the
left in the X-direction in steps of
100 µm. Keep the key pressed to
increase the speed.
Changes to POSITION menu or
moves the specimen holder to the
right in the X-direction in steps of
100 µm. Keep the key pressed to
increase the speed.
Changes to POSITION menu or
moves the specimen holder slowly
to the left in the X-direction in
steps of 5 µm. Keep the key
pressed to increase the speed.
Changes to POSITION menu or
moves the specimen holder slowly
to the right in the X-direction in
steps of 5 µm. Keep the key
pressed to increase the speed.
Changes to POSITION menu or
moves the specimen holder up- or
downwards in the Y-direction in
steps of 100 µm. Keep the key
pressed to increase the speed.