Struers Accutom-5 Mode D'emploi page 3

Accutom-5
Instruction Manual
Accutom-5
Safety Precaution Sheet
To be read carefully
before use
1. The operator should be fully instructed in the use of the machine and its
cut-off wheels according to the Instruction Manual and the instructions
for the cut-off wheels.
2. The machine must be placed on a safe and stable support table.
3. Be sure that the actual voltage corresponds to the voltage stated on the
back of the machine. The machine must be earthed.
4. Use only intact cut-off wheels. The cut-off wheels must be approved for
min. 3000 rpm. If other cut-off wheels or saw blades are used, make
sure that the speed setting of Accutom-5 complies with the max. speed
for the cut-off wheels or saw blades.
5. Observe the current safety regulations for handling, mixing, filling,
emptying and disposal of the additive for cooling fluid.
6. The sample must be securely fixed in the specimen holder.
7. Do not touch the sample, the specimen holder head or the cut-off wheel
while positioning the sample with the POSITION controls.
8. Never try to open the cover before the cut-off wheel has stopped
completely.
The equipment should only be used for its intended purpose and as detailed in the Instruction Manual.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).