Connecting Ac Power; Powering On The Unit; Turning Off The Unit - Sunoptic Surgical HDC-300C Mode D'emploi

4.4.

CONNECTING AC POWER

Ensure the rear power switch is in OFF position.
Connect the AC power cord to the power inlet located on the rear panel of the Camera Console. Ensure
the power cord is completely seated into the power inlet and engage the cord retainer if so equipped.
Use only power cords provided with the HD Camera System.
Plug the AC power cord into a wall outlet using the three (3) prong plug supplied with the unit.
To prevent electric shock, connect power cords of peripheral equipment through medical
isolation transformers.
Note: When using medical isolation transformers, be sure to check the transformer power ratings.
Ensure that the power cord is connected to the main power with three prong plugs (USA use UL2601-1
rated isolation transformers and/or power strips only).
CAUTION:
adverse electromagnetic effects, DO NOT operate this equipment near any RF energy
equipment.

4.5. POWERING ON THE UNIT

After ensuring that all external devices are properly connected, use the switch on the power entry module
on the back of the unit to turn the power ON and the switch will light up GREEN. Once AC power is
applied to the unit, push the On Button on the front panel to turn the unit ON. The Sunoptic splash screen
will appear on the touch screen after turning the unit on.
Please allow approximately 30 seconds for the system to boot.
4.6.

TURNING OFF THE UNIT

After pressing the button on the front of the unit to turn the Camera Console off, allow up to a full minute
for the system to shut down before switching the unit off at the power entry switch or trying to unplug the
unit.
Please allow approximately 30 seconds for the system to shut down completely.
LIT-239 SUNOPTIC SURGICAL
Rev. B
Nearby radio or TV units may subject this equipment to radio interference. To avoid
®
Page 11 of 210
(English)