Connecting Light Cable; Operation; Powering Up Illuminator; Touch Screen Functions - Sunoptic Surgical Titan X450 Mode D'emploi

5.2 CONNECTING THE LIGHT CABLE
Connect the fiberoptic cable to endoscope or other instrument and then insert the
cable's illuminator end tip into the appropriate port of the turret on the front panel.
You may notice a very slight normal resistance to insertion as the tip opens the auto
shutter. Push the tip all the way in.

6. OPERATION

6.1 POWERING UP THE ILLUMINATOR
To operate the illuminator: First attach the illuminator to thefiberoptic cable, instrument
or headlamp to be used.Turn on the rear power switch. Turn on the lamp switch.
The on lamp switch will light up and the fan will start.
The touch screen will display for three seconds, followed by the normal operating
6.2

TOUCH SCREEN FUNCTIONS

6.2.1

FAULT CONDITION NOTICES

There are twelve fault conditions detectable by sensors that will render the illuminator
inoperable until they are corrected. A fault condition notice will appear on the screen
identifying the fault and how to correct it.
LIT-219 Sunoptic Surgical
Rev. C
display:
®
Page 10 of 169
(English)