Setup And Interconnection; Setting Up The Console; Connecting The Camera; Connecting Monitors - Sunoptic Surgical HDC-300C Mode D'emploi

4.

SETUP AND INTERCONNECTION

4.1. SETTING UP THE CONSOLE

Place the Camera Console on a stable surface (cart, counter, stand etc.).
NOTE: Avoid places where the console may be splashed with liquid. Absolutely DO NOT use in any
environment with explosive or flammable gases. This camera console pulls cooling air into its cabinet
through a grille in the bottom panel underneath the front portion and exhausts warm air from the fan in
the rear.
DO NOT block the space in front or below the front of the camera console or impede exhaust air flow
behind or above the cabinet.
A Clear space minimum of 5"/12.7cm behind and above the cabinet is required. The console should not
be placed where its exhaust will influence other devices, nor where exhaust from other devices will
influence the unit.

4.2. CONNECTING THE CAMERA

WARNING: THE CAMERA CORD HAS A LOCKING CONNECTOR. TO REMOVE THE CABLE
FROM THE UNIT, GRAB THE CONNECTOR AND PULL THE CONNECTOR OUT. THE
CONNECTOR CANNOT BE REMOVED BY PULLING THE CABLE AND DOING SO MAY
RESULT IN A DAMAGED CABLE (THIS TYPE OF DAMAGE IS NOT COVERED BY THE
PRODUCT WARRANTY).
Ensure that the camera cable is properly inserted into the Camera Port. To do this, rotate the right-angle
connector before inserting until the red dot on the connector aligns with the red dot on the receptacle.
Push in firmly.

4.3. CONNECTING MONITORS

The Sunoptic Technologies High Definition Camera System comes equipped with four (4) video outputs
(two (2) HDMI and two (2) DVI). All four (4) outputs can be used at once and are configured as shown
below.
Output
HDMI 1
HDMI 2
DVI 1
DVI 2
Follow the instructions for setting up the monitor(s) and connect to the Sunoptic HDC-300 Camera
Console using either HDMI or DVI cables.
LIT-239 SUNOPTIC SURGICAL
Rev. B
®
Page 10 of 210
Configuration
Stabilized Video
Stabilized Video
Unstabilized Video
Unstabilized Video
(English)