Diagrams And Drawings - EBARA JESX Manuel D'utilisation Et D'entretien

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

5.1. INSTALLATION

To install the pumps, proceed as directed in PART 1, chapter 7.2

and in the following points:

– use pipes of a suitable diameter, bearing in mind that, in

some models, suction diameter (front side of pump) is great-

er than delivery diameter (top side of pump), (see chap. 4).

5.2. FILLING THE PUMP JE(S)(X) (FIG.1); AG (FIG.2)

WARNING

OPERATION TO BE PERFORMED WITH THE MOTOR'S

TERMINAL STRIP FULLY CLOSED.

a) Unscrew the hexagonal cap (1-2) located on the top of the

pump casing;

6. DIAGRAMS AND DRAWINGS

FIG. 1

DECLARATION OF CONFORMITY TO EC DIRECTIVE 2000/14

We, EBARA PUMPS EUROPE S.p.A., via Campo Sportivo, 30 – 38023 CLES (TN) Italy, hereby declare under own responsibility that our products listed in the

table at the foot of the page are in conformity with EC Directive 2000/14 article 13 and internal production control procedure according to appendix V.

Lwa (M): sound power level (A-weighted), measured• Lwa (G): sound power level (A-weighted), guaranteed. (see table at foot of page).

JES M5, JES M6, JES M8, JESX M5, JESX M6,

JESX M8, AGE 050M, AGE 060M, AGE 080M,

AGF 060M, AGF 080M, AGF 060M, AGF 080M

Lwa (M)

74 dB/pW

Lwa (G)

76 dB/pW

b) With the aid of a funnel, ﬁ ll the pump with water to over-

ﬂ owing;

c) Screw the hexagonal cap back on until it is locked tight to

prevent air getting in.