Use; Codes - Sonnenkonig FRESCO 1000 Mode D'emploi

11 Use

When using the cooling function:
1. Unpack the unit and fix part a and part b together as schown in Fig. 1 Rotate the exhaust
hose clockwise to attach to the adapter.
2. Fix the adapter to the unit as schown in Fig. 2, rotate the exhaust hose clockwise to attach to
the adapter.
3. Rotate the adapter clockwise until it stops, and then you can remove the adapter from the
cool air outlet.
When operating heating function:
1. Remove the outlet and the exhaust hose, then attach the two subassemblies
2. Fix the adapter to the cool air outlet.
3. Rotate the exhaust hose clockwise to attach to the adapter.
Note: For the best results in cooling/heating mode, please remove the baffle plate.

12 Codes

Problem
dH
E1
E2
E4
Cause
Dehumidification mode
active
Electrical short on both
temperature sensors and
the PCB
Electrical short of the tem-
perature sensor, the copper
tube or the PCB wiring
Indicates that the water tank
is full or the plug may be
incorrectly wired
77
Trouble shooting
-
Contact an electrician for
repair
Contact an electrician for
repair
Pull out the rubber stopper
that is located at the bottom
of the unit, to drain the wa-
ter. Check that the plug has
been wired correctly.
EN