Control Panel & Description Of Function - Sonnenkonig FRESCO 1000 Mode D'emploi

5 Control panel & description of function
1. POWER BUTTON
Press to turn the unit "ON" or "OFF".
2. FUNCTION
Press this button to select cooling, heating, or dehumidifying.
3. TEMPERATURE ADJUSTMENT BUTTON (up)
In cooling mode: This button raises the preset temperature by 1° C each time it is pressed, the
maximum limit is 30° C. In heating mode: this button raises the preset temperature by 1° C
each time it is pressed, the maximum limit is 25° C.
4. TEMPERATURE ADJUSTMENT BUTTON (down)
In cooling mode: this button lowers the preset temperature by 1° C.each time it is pressed, the
minimum limit is 17° C. In heating mode: this button lowers the preset temperature by 1° C
each time it is pressed, the minimum limit is 15° C.
5. LED DISPLAY
The display indicates the current temperature setting or timer setting. When the set tempera-
ture or the timer are adjusted, the new setting is shown then the display reverts to the current
set temperature.
– The display is also used to display error codes should a fault occur, see ERROR CODES.
6. SPEED
Press to select either LOW, MEDIUM, HIGH or AUTO fan speed. If "AUTO" is selected (in cooling
mode), "HIGH", "MEDIUM", or "LOW" will be automatically selected according to the difference
between the temperature setting and the ambient temperature.
Note: In heating mode and dehumidifying mode, this button can not be operated because the unit
is preset to high speed in heating mode and low speed in dehumidifying mode.
7. PROGRAMMABLE TIMER
Programmable timer ON/OFF button.
71
EN