Sleep Function - Sonnenkonig FRESCO 1000 Mode D'emploi

TIMER ON: The unit switches on.
1. Press the "TIMER" button in stand-by mode to set the time you desire.
2. Once the set time has elapsed, the unit will turn on automatically.
3. If you press the "POWER" button before the time has elapsed, the timer setting will be
canceled and the unit will turn on.
4. You can set the mode and fan speed while setting the timer.
TIMER OFF: The unit switches off automatically after the set has elapsed.
EN
1. Press the "TIMER" button when the unit is operating to set the time you desire.
2. Once the set time has elapsed, the unit will turn off automatically.
3. If you presse the "POWER" button before the time has elapsed, the timer setting will be
canceled and the unit will turn off.
8. DEHUMIDIFICATION FUNCTION
If the humidity in the room is above the predefined value, the device starts to extract the
humidity. Once the desired humidity has been reached, the compressor and fan enter standby
mode. If the room humidity again exceeds the predefined value, the unit is reactivated.

9. SLEEP FUNCTION

In sleep mode, the appliance can be operated automatically in heating and cooling mode so
that the appliance only switches on when the desired temperature is exceeded or not reached.
The appliance ensures that the desired temperature does not drop or rise by more than 1° C
every hour.
1. In cooling mode, press the SLEEP button to set the temperature. It increases by 1° C after an
hour and at increases by a maximum 2° C after 2 hours.
2. In heating mode, press the SLEEP button to set the temperature. It decreases by 1° C after an
hour and decreases 2° C after 2 hours.
3. Press the "SLEEP" button again to cancel the setting.
10. WATER LEVEL ALARM
When the water tank is full, "E4" will be displayed on the display panel. To resume operation,
please remove the rubber cap from the drainage hose to drain the water first. The "E4" warning
will disappear after draining, and then you can restart the unit by pressing the "POWER"
button.
72