Remote Control - Sonnenkonig FRESCO 1000 Mode D'emploi

6 Remote control

7 Important informations
This unit can evaporate condensation and disperse it automatically through the exhaust hose.
1. When the unit is in cooling mode, the drainage pipe does not need to be attached. Please
make sure that the rubber cap is firmly inserted in the drainage hole, when the unit is
running.
2. When operating in heating mode, the rubber cap "1" should be removed from the drainage
hole and a suitable drainage pipe attached in order to improve heating performance.
3. When operating in dehumidifying mode the rubber cap "1" should be removed from the
drainage hole and a suitable drainage attached.
– Please remove the air exhaust hose, connect a drainage pipe to the drainage hole and direct
the water outside to improve dehumidifying performance.
– When the water tank is full, "E4" will be displayed on the display panel. Please remove the
rubber cap "2" from the drainage hole to drain out the water. After the drainage has been
fully drained, please restart the unit, and will then can operate normally.
1. POWER – On/Off switch
2. FUNC – "MODE" selector
3. TIMER– Timer programming
4. AUTO – Automatic fan speed
5. HI – High fan speed
6. MID – Medium fan speed
7. LOW – Low fan speed
8. SLEEP – Night operation selector
9. TEMP – Temperature selector
73
EN