Indicator Charge Level; Charging Process; Insert/Remove Battery; Charge Battery - Grizzly ARM 2433-20 Traduction De La Notice D'utilisation Originale

6. To switch off, release the start
lever (16).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.

Indicator charge level

Press the „Press" button on the right of
charging level indicator (see Figure
in order to check the status of the battery.
The number of illuminated LED lights
shows the charge level of the battery.
4 lights means battery is fully charged.
1 light means that the battery needs to be
charged.

Charging process

Do not expose the battery to
extreme conditions such as heat
or impact. Risk of injury from
escaping electrolytic solution!
After eye/skin contact, rinse the
affected areas with water or a
neutraliser and consult a doctor.
Charge the battery in a dry
room only. Prior to attaching the
charger, check that the battery's
outer surface is clean and dry.
There is a risk of injury due to
electric shock.
Only use the charger from the
package to charge the battery.
• Charge the battery before the first time
of use. Do not briefly charge the bat-
tery several time in a row.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
11b) information.
I
• The warranty excludes all defects
caused by improper handling.

Insert/remove battery

Switch off the device, pull the
ignition key (12) and wait for the
blades to come to a stop. There is
a risk of personal injury.
G
1. To insert the battery (11) into the
2. To remove the battery (11) from

Charge battery

Allow a freshly charged battery (11)
to cool down for approx. 15 min-
utes before inserting it into the bat-
tery charger (17).
I
1. Remove the battery (11) from
2. Insert the battery (11) in the
device, push the battery along
the guide rail into the device. It
locks into place audibly.
the device, press the release
button (11a) on the battery and
pull the battery out.
the appliance, as necessary.
charging compartment of the
battery charger (17). It will audi-
bly snap in.
GB
31