Charging; Charging The Battery; Led On The Charging Station; Checking The Charge Status Of The Battery - Grizzly MR 1000 Traduction De La Notice D'utilisation Originale

GB
confirm the selection with the OK key
(22).
6. Return to the main menu with the
back key (21).

Charging

Do not expose the battery to
extreme conditions such as heat
and shocks. There is a risk of
injury from leaking battery fluid!
In case of contact with eyes or
skin, rinse the affected sites with
water or a neutralising agent and
seek medical attention.
Only charge the battery with the
enclosed charger.
• Charge the battery before using it for
the first time.
• If the operating time is considerably
shortened despite charging, this
shows that the rechargeable battery is
depleted and must be replaced. Only
use an original battery purchased
from customer service.
• Always comply with the latest safety
instructions, as well as the regulations
and information relating to environ-
mental protection.
• Defects resulting from improper han-
dling are not covered by the guaran-
tee.

Charging the battery

The automatic lawn mower automatically
returns to the charging station when it has
a low charge status.
To do so, the automatic lawn mower lo-
cates the nearest boundary wire and fol-
lows this in a clockwise direction.
94

LED on the charging station

No display: Charging station is not con-
nected to the mains.
Illuminated red: Battery
charging.
Illuminated green: Battery
fully charged.
Checking the charge status of
the battery
You can check the charge status of the
automatic lawn mower on the LCD display
at any time.
1. Open the cover on the LCD display
(2).
2. Unlock the LCD display (23) with the
4-digit PIN.
The charge status is now shown by
the battery symbol in the bottom right
corner.
3. Close the cover on the LCD display
(2). The automatic lawn mower re-
sumes its previous activity without
interruption.

Practical tips

Regular mowing stimulates the grass to
an increased leaf formation, while at the
same time killing weeds. Therefore, the
lawn becomes denser after each mowing
process, resulting in an evenly loadable
lawn.
Flashing green:
Boundary wire dam-
aged or incorrectly
connected.