Faults And Remedies - Brill 38 VLB COMBI CARE Mode D'emploi

Care of the engine
Air filter
„
Spark plug
„
Oil change
„
Drain used oil when the motor is warm. Warm
oil drains quickly and completely.
1. To collect oil, place a suitable container under the engine.
2. Remove the oil dipstick.
3. Screw in the filler neck.
4. Push the beam downwards and tilt the equipment, until
the beam touches the floor. Drain the oil completely.
5. Pull the equipment up and fill with oil (SAE 10W-30,
quantity: 0,25l)
6. Remove the filler neck.
7. Screw in the oil dipstick.
Dispose of used engine oil in a manner that is
compatible with the environment!
We recommend to collect the used oil in a
closed container and to deliver it to a suitable
recycling or service station.
Used oil should not be
disposed of with domestic rubbish
„
poured into the sewage water system or
„
drain pipes
poured on the ground
„
Observe the operating instructions supplied by the en-
gine manufacturer.
Storage
Caution!
Do not store motor near open flames or heating
sources - Burn and/or explosion danger!
Let the engine cool down.
„
Store the scarifier in a dry place.
„
To save storage space, unscrew the butterfly nuts
„
on the beam and fold it in.

Faults and remedies

Fault Remedy
The engine Fill up with petrol
„
does not start
Pull the control bar towards
„
the handle.
Check the spark plugs and
„
replace if necessary.
Clear the air filter.
„
Set a lower cutting height.
„
The roller does See a service station
not turn
Engine power Set a lower cutting height.
„
reduced
Replace the worn blades.
„
Mow the lawn (the grass is
„
too high).
Poor scarifier Set a lower cutting height.
„
performance
Replace the worn blades.
„
Rough run- Damaged blades.
„ „
ning
See a service station.
„
Strong vi-
„
brations
Faults that cannot be rectified with the aid of this table
must be eliminated by an authorised workshop only.
GB
13