Brill 38 VLB COMBI CARE Mode D'emploi page 11

Commissioning
Warning!
Always make a visual inspection of the equipment
before using it. The equipment should not be used
if the cutting unit and/or mounting components are
loose, damaged or worn.
Comply with any national regulations regarding
„
operating times.
Always observe the operating instructions sup-
„
plied by the engine manufacturer.
Safety
Warning!
Fire danger!
Petrol is highly flammable!
Store petrol in designated containers only.
„
Only refuel in open air.
„
Never smoke while refilling!
„
Do not open the tank cap while the engine is run-
„
ning or if the machine is hot.
Replace a damaged petrol tank and/or tank cap.
„
Always close the tank cap.
„
If petrol has been spilt:
„
Do not start the engine
„
Do not start the equipment
„
Clean the equipment
„
Warning!
Never leave an engine running in an enclosed space.
Toxic hazard!
Refilling
Before switching on the machine for the first time, fill
it up with oil and petrol.
Petrol: unleaded regular-grade petrol
Engine observe the operating instructions
oil: supplied by the engine manufacturer.
Oil: SAE 10W-30, capacity: 0,25 l
Oil filling
(picture G)
1. Remove the oil dipstick.
2. Screw in the filler neck.
3. Fill oil.
4. Remove the filler neck.
5. Screw in the oil dipstick.
Petrol filling
(picture H)
The tank cap is on the petrol tank. It is marked
with the symbol "petrol station".
Setting the cutting height
Warning!
The cutting height can be adjusted when the engine
is not running and the cutter spindle is stopped.
Adjust the cutting height of the cutter spindle with the
knob.
1. Push the beam downwards and tilt the scarifier.
2. Push the knob downwards and rotate to position „2".
Knob positions:
1 - 5 = cutting height settings
With new blades, turn the knob to position 2
max.!
The correct cutting height depends on:
lawn conditions
„
blade wear
„
In case the cutting height is not correct:
the scarifier stands still
„
the engine does not pull through
„
In this case, set the knob to a lower cutting height.
GB
(picture I)
11