Fault
Battery runtime drops noticeably
Battery cannot be charged
Motor is running, but cutting
equipment does not turn
Rattling noises, cutting equipment
does not turn uniformly
* PCB = integrated battery protection circuit
Maintenance, cleaning and
storage
For your safety!
It is essential that you also follow the "General safety
instructions" as well as the "Safety instructions for
maintaining and cleaning mower" in chapter
"Important safety instructions".
Caution, risk of injury from rotat-
ing and sharp cutting equipment!
STOP
30
Possible cause
Cutting height too low
Grass too high or too wet
Mowing speed too high
Battery is empty
Contaminated charging plug or
charging socket
Defective battery / charger
Torn tooth belt
Tooth belt is slipping
Maintenance
Maintenance covers all work required to keep the
G
mower in good operating condition. Regular checks
(firm fit of screw connections, cracks, damage) and
replacement of damaged or worn parts will help pre-
vent accidents and mower failures.
Troubleshooting
Increase cutting height,
Allow for grass to dry
Decrease speed
Ensure that cutting equipment
turns freely. Remove clippings from
the area of the mower housing
Replace battery. Use only original
accessories from manufacturer
Clean contacts, plug and unplug
charging plug or charging socket
several times
Replace battery / charger. Use only
original accessories from manufac-
turer
Ensure that repair is only performed
by manufacturer's service centre or
authorised dealers
Caution, risk of injury from rotating cutting
equipment! Before any work on mower always-
disconnect circuit breaker.
Caution, risk of injury from sharp cutting
equipment! Wear protective gloves when per-
forming any work.