Log Placement; Logo Placement - Napoleon GDS20N Instructions D'installation Et D'opération

5.4

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
A. Remove safety screen.
B. Remove cast top.
C. Remove glass door / cast front. See "GLASS
DOOR / CAST FRONT INSTALLATION
REMOVAL" in the Finishing section of this
manual for more information.
NOTE: It is not necessary to remove the cast front.
However, it will make log installation simpler.
D.
Place the rear log, as
shown, onto the rear log
support brackets. Ensure
the cutout on the left
underside of the log fits over
the pilot assembly. Bend the
bracket on the right side to
help retain the rear log.
5.5

LOGO PLACEMENT

Remove the backing from the logo and position onto
the control door as shown.
WARNING
!
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
BRACKET
E.
Place the hole in the
underside of log #2 onto the
locating screw on the left
side of the burner. The fibre
burner is formed to cradle
the centre of the log.
76.1A
LOG LOCATING SCREWS
F.
Place the hole in the
underside of log #3 onto
the locating screw on the
right side of the burner. The
bottom branch of log #3 sits
in front of and against the
right end of log #2.
G.
Reinstall the glass door and
cast front if removed.
H. Reinstall cast top and
safety screen.
1.27cm
LOGO
1.27cm
W415-1326 / B / 08.23.18
27
EN