Pilot Indicator Light Battery Replacement; Orifice Replacement; Care Of Glass - Napoleon GDS20N Instructions D'installation Et D'opération

9.2

PILOT INDICATOR LIGHT BATTERY REPLACEMENT

9.2 PILOT INDICATOR LIGHT BATTERY REPLACEMENT
9.2 PILOT INDICATOR LIGHT BATTERY REPLACEMENT
If the pilot indicator light no longer ashes and the pilot is
If the pilot indicator light no longer ashes and the pilot is
If the pilot indicator light no longer flashes and the pilot is
burning, the batteries may require replacing.
burning, the batteries may require replacing.
burning, the batteries may require replacing.
Four "AA" batteries are required and should be replaced
Four "AA" batteries are required and should be replaced
Four "AA" batteries are required and should be replaced
annually.
annually.
annually.
A. Open the switch housing by removing the top
A. Open the switch housing by removing the top
A. Open the switch housing by removing the top
screw, then pivoting the box open.
screw, then pivoting the box open.
screw, then pivoting the box open.
B. Remove the 4 "AA" batteries and replace using
B. Remove the 4 "AA" batteries and replace using
B. Remove the 4 "AA" batteries and replace using
the new ones.
the new ones.
the new ones.
C.
C. Pivot the box closed and re-secure using the
Pivot the box closed and re-secure using the
C. Pivot the box closed and re-secure using the
screw removed in step A.
screw removed in step A.
screw removed in step A.
9.3

ORIFICE REPLACEMENT

9.3 ORIFICE REPLACEMENT
9.3 ORIFICE REPLACEMENT
A. Remove the cast front and the door, see "GLASS DOOR
A. Remove the cast front and the door, see "GLASS DOOR
A. Remove the cast front and the door, see "GLASS DOOR
/ CAST FRONT INSTALLATION AND REMOVAL" section
/ CAST FRONT INSTALLATION AND REMOVAL" section
/ CAST FRONT INSTALLATION AND REMOVAL" section
in the Finishing section of this manual.
in the Finishing section of this manual.
in the Finishing section of this manual.
B. Remove the 2 securing screws indicated and remove the
B. Remove the 2 securing screws indicated and remove the
B. Remove the 2 securing screws indicated and remove the
burner assembly.
burner assembly.
burner assembly.
C. The orice is located on the left hand side.
C. The orice is located on the left hand side.
C. The orifice is located on the left hand side.
D.
D. Reinstall the burner ensuring that the venturi tube  ts over
Reinstall the burner ensuring that the venturi tube  ts over
D. Reinstall the burner ensuring that the venturi tube fits over
the orice and replace the screws.
the orice and replace the screws.
the orifice and replace the screws.
E. Care should be taken not to damage the gas pipe. When
E. Care should be taken not to damage the gas pipe. When
E. Care should be taken not to damage the gas pipe. When
removing and replacing the orice, using a 9/16" socket
removing and replacing the orice, using a 9/16" socket
removing and replacing the orifice, using a 9/16" socket
wrench, a 7/8" back-up wrench must be used on the
wrench, a 7/8" back-up wrench must be used on the
wrench, a 7/8" back-up wrench must be used on the
manifold, located below the housing, to ensure that the
manifold, located below the housing, to ensure that the
manifold, located below the housing, to ensure that the
aluminum tubing does not twist or kink.
aluminum tubing does not twist or kink.
aluminum tubing does not twist or kink.
9.4

CARE OF GLASS

9.4 CARE OF GLASS
9.4 CARE OF GLASS
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the rst 10 hours of operation with a
of the glass after the  rst 10 hours of operation with a
recommended replace glass cleaner. Thereafter clean
recommended  replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
discoloration and / or blemishes may result.
This appliance is factory equipped with 4mm tempered glass. Use only replacement glass available from your
This appliance is factory equipped with 4mm tempered glass. Use only replacement glass available from your
Napoleon® dealer. DO NOT SUBSTITUTE MATERIALS.
Napoleon® dealer. DO NOT SUBSTITUTE MATERIALS.
+
+
-
-
+
-
- + -
+
- +
-
-
+
+
-
- -
+
+ +
-
+
ORIFICE
ORIFICE
LOCATION
LOCATION
ORIFICE
LOCATION
BURNER
BURNER
ASSEMBLY
ASSEMBLY
BURNER
ASSEMBLY
SCREW
SCREW
LOCATIONS
LOCATIONS
SCREW
LOCATIONS
WARNING
WARNING
!
!
HOT GLASS WILL
HOT GLASS WILL
CAUSE BURNS.
CAUSE BURNS.
DO NOT TOUCH GLASS
DO NOT TOUCH GLASS
UNTIL COOLED.
UNTIL COOLED.
NEVER ALLOW CHILDREN
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
TO TOUCH GLASS.
5.1
5.1
5.5
5.5
W415-1326 / 05.23.14
W415-1326 / 05.23.14
W415-1326 / B / 08.23.18
33
33
33
EN
EN
EN