Mobile Home Installation; Minimum Clearance To Combustibles - Napoleon GDS20N Instructions D'installation Et D'opération

24
4.8

MOBILE HOME INSTALLATION

This Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the appliance.
EN
Built in appliances are equipped with 1/4" diameter holes located in the front left and right corners of the base. Use
appropriate fasteners, inserted through the holes in the base to secure. For free standing products contact your
local authorized dealer / distributor for the appropriate securing kit. For mobile home installations, the appliance
must be fastened in place. It is recommended that the appliance be secured in all installations. Always turn off the
pilot and the fuel supply at the source, prior to moving the mobile home. After moving the mobile home and prior to
lighting the appliance, ensure that the logs are positioned correctly.
This appliance is certifi ed to be installed in an aftermarket permanently located, manufactured (mobile)
home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certifi ed kit is used.
Conversion Kits
This appliance is fi eld convertible between Natural Gas (NG) and Propane (P).
To convert from one gas to another consult your Authorized dealer/distributor.
4.9

MINIMUM CLEARANCE TO COMBUSTIBLES

NOTE: If the appliance is installed directly on carpeting, vinyl tile or other combustible materials other than wood
flooring, the appliance shall be installed on a metal or wood panel extending the full width and depth.
As long as clearance to combustibles is kept within required distances, the most desirable and beneficial
location for an appliance is in the centre of a building, thereby allowing the most efficient use of the heat
created. The location of windows, doors and the traffic flow in the room where the appliance is to be located
should be considered. If possible, you should choose a location where the vent will pass through the house
without cutting a floor or roof joist.
MAINTAIN THESE MINIMUM CLEARANCES TO COMBUSTIBLES:
A. 4" (1219mm)
Appliance top to ceiling
Horizontal vent
Sides and bottom**
Top
Vertical Vent
All sides
* At a distance of 2" (51mm) from the wall, access to the blower switch, on-off switch or the blower power cord
may not be practical. A minimum of 5" (127mm) will be required in order to install the blower.
** HORIZONTAL VENT SECTIONS: A minimum clearance of 1" (25mm) at the bottom and sides and 2"
(51mm) at the top of the vent pipe in all horizontal runs to combustibles is required. Use firestop spacer W585-
0267 (supplied).
** VERTICAL VENT SECTIONS: A minimum of 1" (25mm) all around the vent pipe on all vertical runs to
combustibles is required. Use firestop spacer W500-0097 (not supplied).
W415-1326 / B / 08.23.18
B. 2" (51mm)* C.
(121.9cm)
48" (1219mm)
1" (25mm)
2" (51mm)
1" (25mm)
29.6B
2" (51mm)