Default Parameters - ero electronic LFS Manuel De Service

DEFAULT PARAMETERS

DEFAULT PARAMETERS
DEFAULT PARAMETERS DEFAULT PARAMETERS DEFAULT PARAMETERS
DEFAULT OPERATIVE PARAMETERS DEFAULT OPERATIVE PARAMETERS DEFAULT OPERATIVE PARAMETERS DEFAULT OPERATIVE PARAMETERS DEFAULT OPERATIVE PARAMETERS
The control parameters can be loaded with
predetermined default values. These data are the
typical values loaded in the instrument prior to
shipment from factory. To load the default values
proceed as follows:
a ) The internal switch (V101, see fig. 14) should
be closed.
b) The SMART function should be disabled.
c) The instrument should be in Stand-by mode.
d) Held down pushbutton and press
pushbutton; the display will show:
O F F O F F
O F F O F F O F F
d F L t d F L t
d F L t d F L t d F L t
e ) Press or pushbutton; the display will
show:
O n O n O n
O n O n
d F L t d F L t d F L t
d F L t d F L t
g) Press FUNC pushbutton; the display will show:
LOAd LOAd LOAd LOAd LOAd
It means that the loading procedure has been
initiated.
After about 3 seconds the loading procedure is
finished and the instrument reverts to NORMAL
DISPLAY mode.
Nuovo-6 1
The following is a list of the default operative
parameters loaded during the above procedure:
PARAMETER DEFAULT VALUE
SP = Minimum range-value
SnRT = Disable
n.RSt = OFF
SP2 = Minimum range value
nnn = OFF
AL1, AL2 = Minimum range-value for
process alarms
0 for deviation or band alarms
HSA1, HSA2 = 0.1 %
Pb = 4.0 %
hyS = 0.5 %
ti = 4.00 (4 minutes)
td = 1.00 (1 minute)
I P = 30 %
Cy1 = 15 seconds for relay output
4 seconds for SSR output
Cy2 = 10 seconds for P8 = AIr
4 seconds for P8 = OIL
2 seconds for P8 = H2O
rC = 1.00 for P8 = AIr
0.80 for P8 = OIL
0.40 for P8 = H2O
OLAP = 0
rL = Initial scale value
rH = Full scale value
Grd 1 = Infinite (step transfer)
Grd 2 = Infinite (step transfer)
OLH = 100 %
tOL = Infinite
Hbd = 50 % of the full scale value.
SCA = 100 % of the full scale value.
rnP = 25 % of the output per second.
A. 1
13/07/2004, 14:47