Lamp Test; Smart Function - ero electronic LFS Manuel De Service

LAMP TEST

LAMP TEST LAMP TEST LAMP TEST LAMP TEST
When it is desired to verify the display efficiency,
push FUNC pushbutton for more than 10 s. The
instrument will turn ON, with a 50 % duty cycle,
all the LEDs of the display (we define this function
"LAMP TEST").
No time out is applied to the LAMP TEST.
When it is desired to come back to the normal
display mode, push FUNC pushbutton again.
During the LAMP TEST the instrument continues
to control the process but no keyboard functions
are available (exception made for the FUNC
pushbutton).
LFS-1-CC.P65 22

SMART function

SMART function SMART function SMART function SMART function
It is used to automatically optimize the control
action.
To enable the SMART function, push the FUNC
pushbutton until "Snrt" parameter is shown.
Pushing or set the display "On" and push
the FUNC pushbutton.
The SMRT LED will turn on or flashing according
to the algorithm selected.
When the smart function is enabled, it is possible to
display but not to modify the control parameters.
To disable the SMART function, push the FUNC
pushbutton again until "Snrt" parameter is shown.
Pushing or set the display "OFF" and
push the FUNC pushbutton.
The SMRT LED will turn off.
The instrument maintains the actual set of control
parameters and it enables parameter modifica-
tion.
NOTES NOTES NOTES : 1) When ON/OFF control is pro- NOTES NOTES
grammed (Pb=0), the SMART
function is disabled.
2) The SMART enabling/disabling can
be protected by safety key (see
P27).
GB GB GB GB GB 22
13/07/2004, 14:40