Default Parameters - ero electronic LHI Manuel De Service

APPENDIX A APPENDIX A APPENDIX A APPENDIX A APPENDIX A

DEFAULT PARAMETERS

DEFAULT PARAMETERS DEFAULT PARAMETERS DEFAULT PARAMETERS DEFAULT PARAMETERS
DEFAULT PARAMETERS
Loading Default Operating Parameters
The control parameters can be loaded with prede-
termined default values. These are the settings
loaded into the instrument prior to shipment from the
factory. To load the default values proceed as
follows:
a) Press and hold the key and press the
key; the displays will show:
b) Press either the or key; the display will
show:
c) Press the "FUNC" key; the display will show:
This indicates that the loading procedure has been
initiated. After about 3 seconds the loading procedure
Appendix A.1
2 rue René Laennec 51500 Taissy France
Fax: 03 26 85 19 08, Tel : 03 26 82 49 29
is complete and the instrument reverts to the "Normal
Display Mode." The following is a list of the default
operating parameters loaded during the procedure:
Default Operating Parameters List
Parameter Default Value
Software Key Unlock
Alarm 1 Threshold Initial scale value
Alarm 2 Threshold Initial scale value
Alarm 1 Hysteresis 0.1%
Alarm 2 Hysteresis 0.1%
E-mail:hvssystem@hvssystem.com
Site web : www.hvssystem.com