Default Parameters - ero electronic LFT Manuel De Service

DEFAULT PARAMETERS

DEFAULT OPERATIVE PARAMETERS
The control parameters can be loaded with
predetermined default values. These data are the
typical values loaded in the instrument prior to
shipment from factory. To load the default values
proceed as follows:
a) The internal switch should be closed.
b) The SMART function should be disabled.
c) The instrument should be in Stand-by mode.
d) Held down t pushbutton and press s
pushbutton; the display will show:
O F F
d F L t
e) Press s or t pushbutton; the display will
show:
O n
d F L t
g) Press FUNC pushbutton; the display will show:
LOAd
It means that the loading procedure has been
initiated.
After about 3 seconds the loading procedure is
finished and the instrument reverts to NORMAL
DISPLAY mode.
2 rue René Laennec 51500 Taissy France
Fax: 03 26 85 19 08, Tel : 03 26 82 49 29
The following is a list of the default operative
parameters loaded during the above procedure:
PARAMETER DEFAULT VALUE
Snrt = ON.
n.RSt = OFF
nnn = OFF (UNLOCK)
dELY = 00.00
EV1 = OFF
SP1 = low scale value
Grd1 = "InF"
EV2 = OFF
tin 1 = 00.00
EV3 = OFF
SP2 = low scale value
Grd2 = "InF"
EV4 = OFF
tin 2 = 00.00
EV5 = OFF
rPt = 0
dELY = OFF
AL1 = low range value for process
alarm
Zero for band or deviation
alarms.
HSA1 = 0.1 %
AL2 = low range value for process
alarm
0 for band or deviation alarms.
HSA2 = 0.1 %
Pb = 4.0 %
HYS = 0.5
ti = 04.00 [mm.ss]
td = 01.00 [mm.ss]
CY1 = 15 s when P5 = rEL
4 s when P5 = SSr
rL = low scale value
rH = high scale value
OLH = 100 %
A. 1
E-mail:hvssystem@hvssystem.com
Site web : www.hvssystem.com