ero electronic LFS Manuel De Service page 133

DEFAULT CONFIGURATION DEFAULT CONFIGURATION DEFAULT CONFIGURATION DEFAULT CONFIGURATION DEFAULT CONFIGURATION
PARAMETERS PARAMETERS PARAMETERS PARAMETERS PARAMETERS
The configuration parameters can be loaded with
predetermined default values. These data are the
typical values loaded in the instrument prior to
shipment from factory. To load the default values
proceed as follows:
a ) The internal switch should be open.
b) The upper display will show:
COnF COnF
COnF COnF COnF
c) Push the pushbutton; the display will show
the firmware version.
C0nF C0nF C0nF C0nF C0nF
A. 0 0 A. 0 0 A. 0 0 A. 0 0 A. 0 0
d) Maintaining the pressure on the
pushbutton, push the pushbutton also.
The instrument will show:
O F F O F F O F F
O F F O F F
d F L t d F L t d F L t d F L t d F L t
e ) Press pushbutton to select between table 1
(European) or table 2 (American) default set
parameters; the display will show:
Nuovo-6 2
t b 1 t b 1
t b 1 t b 1 t b 1
d F L t d F L t
d F L t d F L t d F L t
f) Press FUNC pushbutton; the display will show:
LOAd LOAd LOAd
LOAd LOAd
It means that the loading procedure has been
initiated.
After about 3 seconds the loading procedure is
terminated and the instrument reverts to
visualization as in point b.
PARA. TABLE 1 TABLE 2
SEr 1 ErO ErO
SEr 2 1 1
SEr 3 19.20 19.20
SEr 4 7E 7E
P1 3 20
P2 ----. ----.
P3 0 0
P4 400 1000
P5 rEL rEL
P6 rEV rEV
P7 1 1
P8 AIr AIr
P9 H.A. H.A.
P10 OFF OFF
P11 10 10
P12 0 0
P13 H.A H.A.
P14 OPrt. OPrt
P15 0 0
P16 0.1 0.1
A. 2
13/07/2004, 14:47