Assembly And Adjustment - Hilti DSH 600 Mode D'emploi

6. Close the fuel canister.

5.2 Assembly and adjustment

WARNING
Risk of injury. Contact with the rotating cutting disc can lead to injury. Hot parts of the machine or a
hot cutting disc may cause burning injuries.
▶ Before fitting or adjusting any parts of the product, make sure that the engine is switched off, that
the cutting disc has completely stopped rotating and that the product has cooled down.
▶ Wear protective gloves.
5.2.1 Fitting a cutting disc 2, 3,
WARNING
Risk of injury and damage. Unsuitable cutting discs or unsuitable parts used to secure the disc can
suffer irreparable damage during operation or lead to loss of control of the tool.
▶ Make sure that the cutting disc's maximum permissible speed is at least as high as the maximum
speed stated on the tool. Use only cutting discs, flanges and screws that fit the tool.
▶ Use only cutting discs with an arbor size (mounting hole diameter) of 20 mm or 25.4 mm (1").
▶ Use only the large flange with a diameter of 78 mm / 3" to secure an abrasive cutting disc.
CAUTION
Risk of injury and damage. Damaged cutting discs may break.
▶ If the cutting disc has been subjected to an impact, check the disc for damage and replace it if
necessary.
▶ Never use cutting discs that are damaged, run untrue or vibrate.
▶ Don't use synthetic resin-bonded fiber-reinforced cutting discs which have exceeded their use-by
date or already softened due to water absorption.
1. Insert the locking pin in the hole in the drive belt cover and turn the cutting disc until the locking pin
engages.
2. Release the securing screw by turning the screw counterclockwise with the wrench and then remove the
screw and washer.
3. Remove the locking pin.
4. Remove the clamping flange and the cutting disc.
5. Check that the diameter of the arbor hole in the cutting disc to be fitted matches the centering collar of
the cutting disc mounting flange.
Note
The mounting flange has a 20 mm diameter centering collar on one side and a 25.4 mm (1")
diameter centering collar on the other side.
6. Clean the clamping and centering surfaces on the tool and on the cutting disc.
7. Select one of the following alternatives.
▶ Use only the large flange to secure the abrasive cutting disc.
▶ Use the small flange with diamond cutting discs in order to utilize the full cutting depth.
8. Place the cutting disc with centering collar on the drive arbor and check that the direction of rotation is
correct.
◁ The direction-of-rotation arrow on the cutting disc must match the direction of rotation indicated on
the tool.
9. Place the clamping flange and washer on the drive arbor and tighten the securing screw by turning it
clockwise.
10. Insert the locking pin in the locking hole in the drive belt cover and turn the cutting disc until the locking
pin engages.
11. Securely tighten the clamping screw (tightening torque: 25 Nm).
Printed: 30.03.2017 | Doc-Nr: PUB / 5341985 / 000 / 00
4
English 9