Hilti DSH 600 Mode D'emploi page 19

WARNING
Risk of burning injury. The exhaust system gets extremely hot when the engine is running. It stays
hot for a long time after the engine is switched off.
▶ Wear protective gloves and avoid touching the exhaust system.
▶ Do not lay the product down on flammable material while hot.
WARNING
Risk of injury. A damaged exhaust system will raise the noise level above the permissible limit and
thus cause hearing damage.
▶ Never use the product if the exhaust system is damaged, missing or if it has been tampered with.
CAUTION
Risk of burns or injury through pinching the fingers when the water pump is fitted. Touching the
pump housing can cause burning injuries.
▶ Hold the forward grip only at the top and on the left side.
1. If the following equipment exists, also take this action:
DSH 600
▶ Press and hold down the throttle safety grip.
▶ Press and hold down the throttle trigger.
▶ Move the start/stop switch to the "start" position.
▶ Release the throttle safety grip and throttle trigger.
◁ The half-throttle position is activated.
▶ Squeeze the primer bulb 2 to 3 times until the primer bulb is completely filled with fuel.
▶ If the following conditions are met, also take this action:
Conditions: The engine is cold.
▶ Pull the choke lever up.
◁ The choke is activated.
▶ Check that the cutting disc is free to rotate.
▶ Place your left foot on the footplate.
▶ Pull the recoil starter pull handle slowly with your right hand until resistance is perceptible.
▶ Vigorously pull the recoil starter pull handle.
▶ When you hear the engine start to fire (after 2 to 5 pulls of the starter), move the choke lever back
down to its original position.
▶ Vigorously pull the recoil starter pull handle repeatedly until the engine fires.
Note
Too many start attempts with the choke activated will cause the engine to flood.
▶ Briefly press the throttle trigger as soon as the engine fires.
◁ This disengages the half-throttle position and the engine will idle when the throttle trigger is
released.
2. If the following equipment exists, also take this action:
DSH 600-X
▶ Press and hold down the throttle safety grip.
▶ Press and hold down the throttle trigger.
▶ Move the start/stop switch to the "start" position.
▶ Release the throttle safety grip and throttle trigger.
◁ The half-throttle position is activated.
▶ Squeeze the primer bulb 2 to 3 times to fill the primer pump bulb with fuel only when starting with the
engine cold.
▶ Check that the cutting disc is free to rotate.
▶ Place your left foot on the footplate.
▶ Pull the recoil starter pull handle slowly with your right hand until resistance is perceptible.
▶ Vigorously pull the recoil starter pull handle.
Printed: 30.03.2017 | Doc-Nr: PUB / 5341985 / 000 / 00
English 11