Plunge Cutting; Switching Off; Care And Maintenance - Hilti SJT 6-A22 Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.2
Switching on
5
1. Insert the battery.
A safety interlock ensures that the tool doesn't start when the tool is first switched on and the
battery then fitted, i.e. slid into place on the tool.
Pull the on/off switch back and then slide it forward again.
2. To switch the tool on, slide the on/off switch forward.
7.3

Plunge cutting

1. Set the orbital-action adjusting lever to position 0.
2. Bring the front edge of the base plate into contact with the workpiece.
3. Hold the product securely and press the on/off switch.
4. Press the product firmly against the workpiece and begin the plunge cut by slowly reducing the angle of
attack.
5. Once the blade has penetrated right through the workpiece, bring the product into its normal working
position.
▶ The base plate then lies flat on the working surface.
6. Continue to saw along the cutting line.
7.4

Switching off

▶ To switch the tool off, slide the on/off switch back.
8
Removal
8.1
Removing the suction adapter
1. Press the two retaining catches inwards.
2. Pull the suction adapter away from the base plate toward the rear.
3. Pull the vacuum cleaner hose off the suction adapter.
8.2
Removing the guard
1. Remove the battery.
2. Tilt the guard slightly and pull it off toward the front.
8.3
Ejecting the saw blade
WARNING
Risk of injury. Uncontrolled ejection of the saw blade can lead to injury.
▶ When ejecting the saw blade, hold the product in such a way that it presents no risk of injury to persons
or animals.
1. Remove the battery.
2. Push the saw blade release lever to the side, as far as it will go.
▶ The saw blade will be released and ejected.
9

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
Carefully remove stubborn dirt.
Clean the air vents carefully with a dry brush.
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
*2150257*
6
7
8
2150257
English
9

Publicité

Table des Matières
loading

Table des Matières