Installation Instructions; Installation Method Via Clamp - Ayrton WildSun 500 Mode D'emploi

the device is not exposed to extreme heat, moisture or dust.
Please don't project the beam onto combustible substances.
The minimum distance between light-output from the Led
Moving Head and the illuminated surface must be more than
0.5 meter.
If you use the quick lock cam in hanging up the fixture, please
make sure the quick lock fasteners turned in the quick lock
holes correctly.
Operate the device only after having familiarized with its
functions. Do not permit operation by persons not qualified
for operating the device. Most damages are the result of
unprofessional operation.
Please use the original packaging if the device is to be
transported.
For safety reasons, please be aware that all modifications on
the device are forbidden.
If this device will be operated in any way different to the one
described in this manual, the product may suffer damages
and the guarantee becomes void. Furthermore, any other
operation may lead to short-circuit, burns, electric shock,
lamp explosion, crash, etc.

Installation instructions

CAUTION !
Please consider the GB7000.15/EN60598-2-17
and the other respective national norms during
the installation. The installation must only be
carried out by a qualified person.
The applicable temperature for the Led Moving Head is
between 0°C to 40°C. Do not use the Led Moving Head
under or above the temperature.
The installation of the effect has to be built and constructed in
a way that it can hold 10 times the weight for 1 hour without
any harming deformation.
The installation must always be secured with a secondary
safety attachment, e.g. an appropriate safety rope.
Never stand directly below the device when mounting,
removing or servicing the fixture.
The operator has to make sure the safety relating and
machine technical installations are approved by an expert
before taking the device into operation for the first time.
These installations have to be approved by a skilled person
once a year.
CAUTION !
Before taking into operation for the first time, the
installation has to be approved by an expert.
Cautions :
The effect should be installed outside areas where persons
may reach it, walk by or be seated.
Overhead mounting requires extensive experience, including
amongst others calculating working load limits, installation
material being used, and periodic safety inspection of
all installation material and the device. If you lack these
qualifications, do not attempt the installation yourself.
Improper installation can result in bodily injury.
CAUTION !
The electric connection must only be carried
out by a qualified electrician.
Before mounting make sure that the installation area can hold
a minimum point load of 10 times the device's weight.
Connect the fixture to the mains with the power plug.

Installation method via clamp

Please refer to the picture below:
Fix the clamp on the bracket by tighten up the M12 screw
on the bracket to the M13 hole in the middle of the bracket.
Insert the quick-lock fasteners of the first Omega holder into
the respective holes on the bottom of the device. Tighten the
quick-lock fasteners fully clockwise.
Install the second Omega holder.
Pull the safety-rope through the holes on the bottom of the
base and over the trussing system or a safe fixation spot.
6 USER MANUAL