Control Board - Ayrton WildSun 500 Mode D'emploi

OFF: (De-activate WDMX)
In this status, wireless system is not activated, so the
fixture can not log in the transmitter.
REST: (reset WDMX memory)
Can remove the fixture from the connection with the
transmitter, the fixture become free and ready to log in
any transmitter.
4. Setup the wireless system:
a) Connect the transmitter with the DMX controller
b) To make the fixture installed with wireless receiver log in to
the transmitter
Initially, the indicator on the receiver fixture should be in
Solid red
Press and hold the configuration button on transmitter for
less than 3 seconds the red/green LEDs on the transmitter
and the receiver fixture will flash rapidly for about 5 ~
10 seconds while the system goes through its setup
procedure.
Once the receiver fixture is logged in to the transmitter
(T1), the fixture with wireless receiver will keep the memory,
even if restart the power, this unit will log in the transmitter
(T1) automatically.
c) Use the DMX 512 to control the fixture
5. Remove the receivers from transmitter (T1) and to log in
to another transmitter (T2)
Case 1: Remove a receiver:
On the control board of the fixture, enter menu to activated
the function of REST;
The LED for wireless on the fixture should turn to Solid
red; the receiver can log out from the transmitter (T1);
Press the configuration button on transmitter(T2) for less
than 3 second, then the fixture will start to connect with
the transmitter (T2)
Case 2: Remove all receivers from a transmitter (T1) to log
in to T2;
Press and hold the configuration button on the T1 as least
5 seconds, can clear the connection with all the fixtures.
All the red/green LEDs on the receiver fixtures will turn to
Solid red to indicate that the receivers are unassigned and
removed from the transmitter ( T1);
Press and hold the configuration button on the T2 less
then less than 3 second, the fixtures will connect with the
T2
PS:
1. Please log the receivers out from the transmitter after every
job, so that the receivers are in free un assigned state and
ready to be assigned to a transmitter.
2. Do not connect the fixture which is under the communication
of wireless system to the DMX controller, otherwise it will
cause interference from the DMX controller.

Control Board

The Control Board offers several features: you can simply set
the starting address , run the pre-programmed program or
make a reset.
The main menu is accessed by pressing the
the display starts flashing.
Browse through the menu by pressing the
button, button or
button in order to select the desired menu. You can change
the selection by pressing the the
button or button.
Confirm every selection by pressing the
leave every mode by pressing the
provided are described in the following sections. it will exit
from flash 10 seconds after the last keypress. Press this key
under edit mode. The functions provided are described in the
following sections.
To access the display menu via the internal battery, press
the DSP button for 2 seconds; To shut off the display
immediately, choose the commend « Reset All» menu
and press «Enter» button, otherwise, the display will
automatically switch off about 1 minute from last button
press.
8 USER MANUAL
button until
button,
button. Press the Enter-
button, button,
button. You can
button. The functions