General Guidelines; Installation Instructions - Ayrton icecolor 500 Mode D'emploi

device switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential
that the device should be earthed.
The electric connection must carry out by qualified person.
No move at operating mode.
If the external flexible cable or cord of this luminaire is damaged,
it shall be exclusively replaced by the manufacturer or his service
agent or a similar qualified person in order to avoid a hazard.
Make sure that the available voltage is not higher than stated at
the end of this manual.
Make sure the power cord is never crimped or damaged by
sharp edges. If this would be the case, replacement of the cable
must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use
or before cleaning it. Only handle the power cord by the plug.
Never pull out the plug by tugging the power cord.
Fixtures cannot be installed on combustible substances, keep
more than 50cm distance with wall for smooth air flow, so there
should be no shelter for fans and ventilation for heat radiation.
CAUTION !
PROJECTOR USING CLASS 2 LED SOURCES
(EN60625-1 : 1994)
This device uses multiple high-power (CLASS 2) LED
(Light Emitting Diode) light sources.
If the external flexible cable or cord of this luminaire is damaged,
it shall be exclusively replaced by the manufacturer or his service
agent or a similar qualified person in order to avoid a hazard.
CAUTION !
Never touch the device during operation !
The housing may heat up.
CAUTION !
Never look directly into the light source, as
sensitive persons may suffer an epileptic shock.
Please be aware that damages caused by manual modifications
to the device are not subject to warranty. Keep away from
children and non-professionals.

General guidelines

This device is a lighting effect for professional use on stages,
in discotheques, theatres, etc., the device was designed for
indoor and outdoor use.
This fixture is only allowed to be operated with the max alternating
current which stated in the technical specifications in the last
page of this manual.
Lighting effects are not designed for permanent operation.
Consistent operation breaks may ensure that the device will
serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or
operating the device.
While choosing the installation-spot, please make sure that the
device is not exposed to extreme heat, moisture or dust. Please
don't project the beam onto combustible substances. The
minimum distance between light-output from the projector and
the illuminated surface must be more than 0.5 meter.
If you use the quick lock cam in hanging up the fixture, please
make sure the quick lock fasteners turned in the quick lock holes
correctly.
Operate the device only after having familiarized with its functions.
Do not permit operation by persons not qualified for operating
the device. Most damages are the result of unprofessional
operation.
Please use the original packaging if the device is to be
transported.
For safety reasons, please be aware that all modifications on the
device are forbidden.
If this device will be operated in any way different to the one
described in this manual, the product may suffer damages and
the guarantee becomes void. Furthermore, any other operation
may lead to short-circuit, burns, electric shock, lamp explosion,
crash, etc.
This device is a lighting effect for professional use on stages, in
discotheques, theatres, etc.
This fixture is only allowed to be operated with the max alternating
current which stated in the technical specifications in the last
page of this manual, the device was designed for indoor and
outdoor use.

Installation instructions

The applicable temperature for the projector is between -20°C to
40°C. Do not use the projector under or above the temperature.
The installation of the effect has to be built and constructed in a
way that it can hold 10 times the weight for 1 hour without any
USER MANUAL
5
CAUTION !
Please consider the GB7000.15/EN60598-2-17
and the other respective national norms during
the installation. The installation must only be
carried out by a qualified person.