Warnings; Machinery General Safety Warnings - Promac 930VLB Instructions De Fonctionnement

Warnings

- Misuse of this machine can cause serious
injury.
- For safety, machine must be set up, used and
serviced properly.
- Read, understand and follow instructions in the
Operating Instructions and Parts Manual which
was shipped with your machine.
When setting up machine:
- Always avoid using machine in damp or poorly
lighted work areas.
- Always be sure the machine support is securely
anchored to the floor or the work bench.
When using machine:
- Always wear safety glasses with side shields
- Never wear loose clothing or jewelry.
- Never overreach—you may slip and fall.
When servicing machine:
- Always disconnect the machine from its
electrical supply while servicing.
- Always follow instructions in Operating
Instructions and Parts Manual when changing
accessory tools or parts.
- Never modify the machine without consulting
JET.
You—the stationary power tool user—hold the
key to safety.
Read and follow these simple rules for best results
and full benefits from your machine. Used properly,
JET machinery is among the best in design and
safety. However, any machine used improperly can
be rendered inefficient and unsafe. It is absolutely
mandatory that those who use our products be
properly trained in how to use them correctly.
They should read and understand the Operating
Instructions and Parts Manual as well as all labels
affixed to the machine. Failure in following all of
these warnings can cause serious injuries.
Machinery General Safety
Warnings
1. Always wear protective eye wear when
operating machinery. Eye wear shall be
impact resistant, protective safety glasses
with side shields which comply with ANSI
Z87.1 specifications. Use of eye wear which
does not comply with ANSI Z87.1
specifications could result in severe injury
from breakage of eye protection.
2. Wear proper apparel. No loose clothing or
jewelry which can get caught in moving
parts. Rubber soled footwear is
recommended for best footing.
3. Do not overreach. Failure to maintain
proper working position can cause you to
fall into the machine or cause your clothing
to get caught, pulling you into the machine.
4. Keep guards in place and in proper working
order. Do not operate the machine with
guards removed.
5. Avoid dangerous working environments. Do
not use stationary machine tools in wet or
damp locations. Keep work areas clean and
well lit.
6. Avoid accidental starts by being sure the
start switch is "OFF" before plugging in the
machine.
7. Never leave the machine running while
unattended. Machine shall be shut off
whenever it is not in operation.
8. Disconnect electrical power before
servicing. Whenever changing accessories
or general maintenance is done on the
machine, electrical power to the machine
must be disconnected before work is done.
9. Maintain all machine tools with care. Follow
all maintenance instructions for lubricating
and the changing of accessories. No
attempt shall be made to modify or have
makeshift repairs done to the machine. This
not only voids the warranty but also
renders the machine unsafe.
10. Machinery must be anchored to the floor.
11. Secure work. Use clamps or a vise to hold
work, when practical. It is safer than using
your hands and it frees both hands to
operate the machine.
12. Never brush away chips while the machine
is in operation.
4