Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB - ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new PROMAC-machine. This manual has been
prepared for the owner and operators of a JDT-2512V or JDT-3216V drilling machine to promote safety during installation,
operation and maintenance procedures. Please read and understand the information contained in these operating instructions and
the accompanying documents. To obtain maximum life and efficiency from your machine, and to use the machine safely, read this
manual thoroughly and follow instructions carefully.
...Table of Contents
Warnings
4. Machine specifications
Technical data
Noise emission
Contents of delivery
5. Transport and start up
Transport and installation
Positioning the machine
Minimum housing requirements
Chosing the spindle speed
Adjusting table and rack height
1. Declaration of conformity
On our own responsibility we hereby
declare that this product complies with
the regulations* listed on page 2.
Designed in consideration with the
standards**.
2. PROMAC Warranty
TOOL FRANCE SARL guarantees that
the supplied product(s) is/are free from
material defects and manufacturing
faults.
This warranty does not cover any
defects which are caused, either
directly or indirectly, by incorrect use,
carelessness, damage due to
accidents, repairs or inadequate
maintenance or cleaning as well as
normal wear and tear.
Further details on warranty (e.g.
warranty period) can be found in the
General Terms and Conditions (GTC)
that are an integral part of the contract.
These GTC may be viewed on the
website of your dealer or sent to you
upon request.
TOOL FRANCE SARL reserves the
right to make changes to the product
and accessories at any time.
3. Safety
3.1 Warnings
-
Misuse of this machine can cause
serious injury.
-
For safety, machine must be set up,
used and serviced properly.
-
Read, understand and follow
instructions in the Operating
Instructions and Parts Manual which
was shipped with your machine.
When setting up machine:
-
Always avoid using machine in
damp or poorly lighted work areas.
-
Always be sure the machine support
is securely anchored to the floor or
the work bench.
When using machine:
-
Always wear safety glasses with
side shields
- Never wear loose clothing or jewelry.
-
Never overreach-you may slip and
fall.
When servicing machine:
-
Always disconnect the machine
from its electrical supply while
servicing.
-
Always follow instructions in
Operating Instructions and Parts
Manual when changing accessory
tools or parts.
-
Never modify the machine without
consulting PROMAC.
You-the stationary power tool
user-hold the key to safety.
Read and follow these simple rules for
best results and full benefits from your
machine. Used properly, PROMAC
machinery is among the best in design
and safety. However, any machine
used improperly can be rendered
inefficient and unsafe. It is absolutely
mandatory that those who use our
products be properly trained in how to
use them correctly. They should read
and understand the Operating
Instructions and Parts Manual as well
as all labels affixed to the machine.
Failure in following all of these warnings
can cause serious injuries.
3.2 Machinery General Safety
Warnings
1. Always wear protective eye wear
when operating machinery. Eye
wear shall be impact resistant,
protective safety glasses with side
shields which comply with ANSI
Z87.1 specifications. Use of eye
wear which does not comply with
ANSI Z87.1 specifications could
result in severe injury from breakage
of eye protection.
2. Wear proper apparel. No loose
clothing or jewelry which can get
caught in moving parts. Rubber
soled footwear is recommended for
best footing.
Publicité
Chapitres
Table des Matières
