Connection; Connecting The Luminaire Without Plug-In Connector - Waldmann ACANEO Mode D'emploi

ENG
X Hold the luminaire between the holder D
and insert the right set screw C from
the inside into the bore of the holder,
see Fig. 9.
X Slightly spread the holder and insert the
left set screw on the other side into the
bore of the holder.
X Secure each of the two sides of the lu-
minaire with a washer F and a hexa-
gon nut E.
Fig. 10: Aligning the luminaire.
X Align the luminaire, see Fig. 10.
Fig. 11: Fixing the luminaire.
X Tighten the hexagon nuts E to a torque
of 20 Nm on both sides of the luminaire,
see Fig. 11.
22
+ –
90°
E
4.

Connection

NOTICE
Material damage caused by wrong
mains voltage.
Damage or destruction of the luminaire.
X Connection by a skilled electrician
only.
X Compare the mains voltage with
the nominal voltage and the fre-
quency specified on the rating
plate and make sure that they are
identical.
4.1 Connecting the luminaire
without plug-in connector
Colour of the
wire
brown
black
grey
blue
yellow/green
Tab. 2: Terminal assignment with "DALI/CLO",
"DALI" or "1-10 V" version.
Colour of the
wire
brown
blue
yellow/green
Tab. 3: Terminal assignment with "EA" , "F" ver-
sion.
NOTE: Observe the terminal assignment,
see Tab. 2 and see Tab. 3.
X Connect the wires to a suitable power
supply.
Connection
Assignment
L1
DALI / +
DALI / −
N
PE
Assignment
L1
N
PE