Installing The Grass Collection Box; Filling With Engine Oil And Checking The Oil Level - Grizzly BRM 4210-20 Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
3. Lock the quick clamping levers
(25) to the upper grip handle (1)
as described below 2.
4. Fasten the Bowden cable (5)
using a cable clamp (6) to the
bottom handle (4).
Installing the Grass Collection
Box
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Push basket rods (29) into bas-
ket net (20).
2. Pull plastic loops (28) over bas-
ket rods.
Fixing the Grass Collection
Box onto the Equipment:
3. Lift up shock protection (22).
4. Hook the grass collection box
(20) into the mounting provided
for this (30) on the rear of the
equipment.
5. Release the impact protection
(22). It holds the grass collec-
tion box in position.
Grass bag fi lling indicator
A textile display is attached to
the top of the grass bag (20).
At an empty grass bag infl ates
the fi ll indicator in the operating.
The fi ll indicator to coincide in
full catcher. In this case, imme-
diately empty the grass bag.
In heavily polluted grass bag fab-
ric the fi ll indicator can not infl ate
himself. The function of the check
indicator is not guaranteed. Imme-
diately clean the grass bag fabric.
Dismantling/Empty out the
Grass Collection Box:
6. Lift the impact protection (22)
and remove the grass collection
box (20)
7. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Screw off the oil tank cap with
dipstick (19) and fi ll up the oil
tank with motor oil using the fun-
nel (
0.4 l oil. Use brand oil (e.g. SAE
30).
2. To check the oil level, wipe the
dipstick (19) on a clean cloth
and replace it in the tank until it
stops.
3. After pulling it out, read off
the oil level on the dip-
stick. The oil level should
be in the marked area be-
tween the minimum and
maximum marks.
4. Wipe off any spilt oil and close
the oil fi ller cap (19).
34). The oil tank holds
GB
87

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Brm 4210-20 a

Table des Matières