Log Placement - Napoleon HD35NT-2 Instructions D'installation Et D'opération

36
6.3

log placement

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
The individual logs can be easily identified by the numbers cast on the underside of each log.
Phazer logs and glowing embers exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect that
TM
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing
effect. During the initial use of the appliance, log colours may vary. During the initial use of the appliance the
colours will become more uniform as colour pigments burn in during the heat activated curing process.
LOGS
Rear Log
Middle Log
Left Log
Right Log
Charcoal Strip Log
Base Left Log
Base Right Log
Place the rear log (W135-0339) on rear bracket, ensure the log is
A.
seated properly on the rear bracket and located on the center pin.
Place the middle log (W135-0409) on top of the burner pan. Use
B.
the two bottom holes of the log to locate it onto the two pins on the
burner pan.
C. HD35-2 / HD40-2: Place the log charcoal strip (W135-0408) on top
of the front grate by engaging the two cut out notches onto the two
middle posts of the front grate.
HD46-2: Place the log charcoal strip (W135-0408) on top of the
support ember strip.
W415-2197 / A / 09.14.17
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
LOG IDENTIFICATION CHART
HD35-2 HD40-2
W135-0339 W135-0339
W135-0409 W135-0409
W135-0406 W135-0406
W135-0407 W135-0407
W135-0408 W135-0408
N/A N/A
N/A N/A
WARNING
!
HD46-2
W135-0339
W135-0409
W135-0406
W135-0407
W135-0408
W135-0392
W135-0393
76.1A