Mobile Home; Access Panel For Gas Line Connection - Napoleon HD35NT-2 Instructions D'installation Et D'opération

4.4

mobile home

This appliance must be installed in accordance with the manufacturer's instructions and the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States or the Mobile Home
Standard, CAN/CSA Z240 MH Series, in Canada. This appliance is only for use with the type(s) of gas
indicated on the rating plate.
This Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the appliance.
Built in appliances are equipped with 1/4" (6.4mm) diameter holes located in the front left and right corners of the
Built in appliances are equipped with 1/4" (6.4mm) diameter holes located in the front left and right corners of the
base, Use #10 hex head screws, inserted through the holes in the base to secure. For free standing products
base. Use appropriate fasteners, inserted through the holes in the base to secure. For free standing products
contact your local authorized dealer / distributor for the appropriate securing kit. For mobile home installations,
contact your local authorized dealer / distributor for the appropriate securing kit. For mobile home installations,
the appliance must be fastened in place. It is recommended that the appliance be secured in all installations.
the appliance must be fastened in place. It is recommended that the appliance be secured in all installations.
Always turn off the pilot and the fuel supply at the source, prior to moving the mobile home. After moving the
Always turn off the pilot and the fuel supply at the source, prior to moving the mobile home. After moving the
mobile home and prior to lighting the appliance, ensure that the logs are positioned correctly.
mobile home and prior to lighting the appliance, ensure that the logs are positioned correctly.
This appliance is certifi ed to be installed in an aftermarket permanently located, manufactured (mobile)
home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certifi ed kit is used.
Conversion Kits
This appliance is fi eld convertible between Natural Gas (NG) and Propane (P).
To convert from one gas to another consult your Authorized dealer/distributor.
4.5

access panel for gas line connection

Remove the 2 screws holding the grate in place.
A.
Unscrew the 4 screws that hold the Access Panel
B.
to the firebox.
Remove the gasket (careful not to tear).
C.
25
29.1C
Access
Panel
Gasket
W415-2197 / A / 09.14.17
EN