Optional Blower Installation; Accessing The Blower - Napoleon HD35NT-2 Instructions D'installation Et D'opération

7.0 optional blower installation

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
7.1

accessing the blower

BE CAREFUL NOT TO TEAR THE BURNER TRAIN GASKET. A REPLACEMENT GASKET CAN BE
ORDERED FROM YOUR LOCAL AUTHORIZED DEALER / DISTRIBUTOR.
NOTE: If optional brick panels have
been installed, they will need to be
removed prior to proceeding.
Remove the control access
A.
panel.
Remove the door, see the
B.
section "DOOR REMOVAL /
INSTALLATION".
Carefully remove the log set
C.
and optional brick panels if
installed, see section "LOG
PLACEMENT".
Remove the 2 screws holding
D.
the front grate in place.
Remove the 2 screws holding the rear log support.
E.
Remove the 9 perimeter screws as illustrated and lift out the burner base assembly and gasket. (The gas
F.
line flex-connector should provide sufficient movement to permit shifting the burner assembly on its side).
WARNING
!
RISK OF FIRE AND ELECTRICAL SHOCK.
VOID THE WARRANTY AND CERTIFICATION.
CORD BENEATH THE APPLIANCE.
CONTACT WITH MOVING OR HOT OBJECTS.
WARNING
!
FRONT
GRATE
CONTROL ACCESS PANEL
PERIMETER SCREWS
SPEED CONTROL
BRACKET
51.5
PERIMETER SCREWS
REAR LOG
SUPPORT
SPEED CONTROL
BRACKET
GASKET
FRONT
REAR LOG
GRATE
SUPPORT
CONTROL ACCESS PANEL
BLOWER
W415-2197 / A / 09.14.17
39
EN