Setting The Standard Gateway - Steca Grid Connect Instructions D'installation Et De Service

Press the Enter key to open the LAN SETTINGS menu.
2 2 
3 3
Press the Enter key to open the IP SETTINGS menu.

4 4
Press the arrow keys until you reach the Subnet mask menu item.

5 5
Press the Enter key to open the Subnet mask menu.

The menu item Subnet settings shows the current subnet mask of

the StecaGrid Connect.
6 6
Press the Enter key to select the first number.

The first number blinks.

7 7
Change the first number with the arrow keys.

8 8
Press the Enter key to set the first number.

The second number blinks.

9 9
Change the second number with the arrow keys.

10 10
Press the Enter key to set the second number.

The third number blinks.

11 11
Change the third number with the arrow keys.

12 12
Press the Enter key to set the third number.

The fourth number blinks.

13 13
Change the fourth number with the arrow keys.

14 14
Press the Enter key to set the fourth number.

NOTE
Activate the LAN settings when you do not wish to make any further LAN set-

tings (see page 40).

Setting the standard gateway

The StecaGrid Connect standard gateway does not need to be configured if com-
munication with PCs outside the LAN is not required. In local networks that use a
router for common Internet access, the (internal) IP address of the router must be
set as the standard gateway for every connected StecaGrid Connect device. The
configuration of the standard gateway (default gateway) is done using the inverter
display, in the same menu and in a similar manner to configuration of the IP address
and subnet mask.
38
EN
IP SETTINGS
> Ip address
Subnet mask
Default Gateway
71.716 | 07.06