Steca Grid Connect Instructions D'installation Et De Service page 29

EN
12 12
Connect an RJ45 plug to the other end of the UTP cable.

NOTE
Make sure that the conductors of the UTP cable are correctly connected to

the RJ45 plug. Use a 1-to-1 cable for connecting the StecaGrid Connect to a
network (switch or hub). Use a crossover cable for direct connection to a PC
(see page 45).
13 13
Close the door of the connection box.

14 14
Screw the 6 screws back into the door of the connection box.

15 15
Connect the StecaGrid Master inverter to the mains grid.

16 16
Connect the UTP cable to the PC or the network.

71.716 | 07.06
9